Golden Jubilee
Posts: 605
Joined: Sat Dec 01, 2012 5:33 am
Location: Conneaut Lake, PA
The old and reliable.
Golden Jubilee
Posts: 605
Joined: Sat Dec 01, 2012 5:33 am
Location: Conneaut Lake, PA
Site Admin
Posts: 4938
Joined: Thu Nov 29, 2012 9:10 am
Location: Nampa, Idaho
Golden Jubilee
Posts: 630
Joined: Fri Nov 30, 2012 10:04 pm
Rusty Driver
Posts: 160
Joined: Thu Nov 29, 2012 8:21 pm
Location: Grand Forks, N.D.
Golden Jubilee
Posts: 605
Joined: Sat Dec 01, 2012 5:33 am
Location: Conneaut Lake, PA
Rusty Driver
Posts: 160
Joined: Thu Nov 29, 2012 8:21 pm
Location: Grand Forks, N.D.
Golden Jubilee
Posts: 5206
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Golden Jubilee
Posts: 605
Joined: Sat Dec 01, 2012 5:33 am
Location: Conneaut Lake, PA
Rusty Driver
Posts: 160
Joined: Thu Nov 29, 2012 8:21 pm
Location: Grand Forks, N.D.
tom fleming wrote:I found the printed copy of the original specs from the old site. Here is the info
Tom, I have an original crank hande. The rod diameter is 3/4", the length of the main shaft is 22" to the bend, the offset is 10" to the handle, then the handle is 4 1/2". The pin is set back a 1/2" from the end and is 3/8" diameter by 1 1/2" long.
Golden Jubilee
Posts: 1289
Joined: Sun Dec 02, 2012 7:54 am
Location: Richland, WA
Users browsing this forum: No registered users and 10 guests