WHAT DID YOU DO IN YOUR SHOP TODAY


Just keep it clean please....

Golden Jubilee
Golden Jubilee

Posts: 3367

Joined: Thu Nov 29, 2012 9:28 pm

Location: Lyman, IA

Post Wed Jul 11, 2018 8:19 pm

Re: WHAT DID YOU DO IN YOUR SHOP TODAY

Not worth that much here either, which is why I still have it. Not sitting on any "goldmine". Like most stuff I own, worth more to me than I could get for it.

Golden Jubilee
Golden Jubilee

Posts: 6353

Joined: Thu Dec 27, 2012 12:45 pm

Location: Canada's left Coast

Post Sun Jul 15, 2018 6:54 pm

Re: WHAT DID YOU DO IN YOUR SHOP TODAY

On CB89's best advice and suggestion, I plugged a furnace fan into one of my retractable cord units. I started with the cord mostly retracted. After 5 minutes of running the fan at 25% I pulled the out fully and the cord had become warm. Two hours of continuous running of the fan did not appear to heat the cord when it was out.
I would rather have tools I do not need than to need tools I do not have

Golden Jubilee
Golden Jubilee

Posts: 6353

Joined: Thu Dec 27, 2012 12:45 pm

Location: Canada's left Coast

Post Wed Jul 18, 2018 7:47 pm

Re: WHAT DID YOU DO IN YOUR SHOP TODAY

It took a little muscle and some shuffling to get my motorcycle out of the shop. Number one concern was not touching my Fat Fender Forty Ford. The motorcycle was sold and the buyer was here to pick it up. I did not like the buyer and there were a few times I was close to telling him to GFY.
I do not know how I feel, just yet. I have been riding since 1961 and this is a big but necessary change, for me.
Now that the motorcycle lift-table/adjustable height work bench is empty, I put my KELLER power hacksaw on the bench. The wiring is at eyelevel and I can finish this project up, seated in comfort.
Attachments
VALKYRIE ON THE LIFT FOR FUSL LEAK.jpg
KELLER ON THE BANCH 3.jpg
KELLER ON THE BNENCH 2.jpg
KELLER ON THE WORKBENCH 1.jpg
I would rather have tools I do not need than to need tools I do not have
Previous

Return to Non-IH discussion

Who is online

Users browsing this forum: No registered users and 0 guests

Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software for PTF.