![User avatar](./download/file.php?avatar=77_1354236348.jpg)
Golden Jubilee
Posts: 759
Joined: Thu Nov 29, 2012 6:44 pm
Location: New Salisbury, IN USA
Re: Disappointed - R112 (long post)
Long-distance diagnosis is SUCH an inexact science...
IHC in the early to mid-fifties.
Golden Jubilee
Posts: 759
Joined: Thu Nov 29, 2012 6:44 pm
Location: New Salisbury, IN USA
Freshly Restored
Posts: 211
Joined: Thu May 10, 2018 7:15 am
Golden Jubilee
Posts: 525
Joined: Mon Dec 17, 2012 10:50 am
Location: Fletcher, OK
Freshly Restored
Posts: 211
Joined: Thu May 10, 2018 7:15 am
waltesefalcon wrote:Do you know someone with a stethoscope that knows how to use it? That would be the best way to figure out just where your noise is coming from.
Golden Jubilee
Posts: 5189
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Freshly Restored
Posts: 211
Joined: Thu May 10, 2018 7:15 am
cornbinder89 wrote:Noise can be a symptom, but not a diagnoses. I had a pick-up come into the shop I was working at with a bottom end knock. It had a 292 Chevy 6 and auto trans. The owner said his wife had driven the truck for 2 1/2 hrs on the hiway with the trans in "2" and not drive. She claimed it wouldn't go over 60 MPH.
I listened to the knock and concluded it came from the crank area, it wasn't until I pulled a few bearings to inspect that I found them all good! There was a definite knock from the oil pan, but it turned out to be a loose torque converter on the flex-plate.
You need someone who can not only know what to listen for, but who will follow through and confirm the diagnoses. In the case above, the owner had been warned it might need a new crank, and was over the moon to learn all it needed was a new flex-plate (the holes had wollowed out) and new bolts.
There are plenty of things that can make a noise, some have been listed, and some have not (carbon, sparkplug wires out of order etc)
Rod bearings tend to get louder as speed increases and the inertia in the rod causes it to knock at both ends of the stroke, mains tend to knock more a low speed. Bad main will wipe out the rod attached to it in short order,as it dumps the oil and little makes it through the drilling to lube the rod.
Golden Jubilee
Posts: 525
Joined: Mon Dec 17, 2012 10:50 am
Location: Fletcher, OK
Golden Jubilee
Posts: 1440
Joined: Fri Nov 30, 2012 6:32 am
Location: Minnesota
Golden Jubilee
Posts: 8954
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Golden Jubilee
Posts: 866
Joined: Wed Sep 05, 2018 1:50 pm
Location: Northern New Mexico
Users browsing this forum: No registered users and 1 guest