Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
IHC in the early to mid-fifties.
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
Rusty Driver
Posts: 169
Joined: Fri Oct 10, 2014 2:25 am
KSever wrote:Installed new gaskets tonight on the valve cover and I may have found why the valve cover was leaking from the rear side. When I tighten down the valve cover to the new rubber gasket all the sides are tight except for the rear, I can move the gasket in and out. I haven't used any gasket sealer yet on this gasket because I still want to adjust the valves. Looks like from the rear the valve cover has a slight bend in the middle. Any body have any good ideas...maybe silicone sealant on the rubber gasket? All my other gaskets are sealed with gasket adhesive (not the silicone type) but I don't think this will seal with the adhesive.
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
Rusty Driver
Posts: 169
Joined: Fri Oct 10, 2014 2:25 am
KSever wrote:Here's the whole side
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
Rusty Driver
Posts: 169
Joined: Fri Oct 10, 2014 2:25 am
KSever wrote:The distributor was just cleaned and painted.
Actually bought a house in Mesa last summer but I have to finish the remodel on this house in Missouri and we plan to list this house to sell in March provided I get the remodel done.
Golden Jubilee
Posts: 1439
Joined: Fri Nov 30, 2012 6:32 am
Location: Minnesota
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
Golden Jubilee
Posts: 8946
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Users browsing this forum: No registered users and 7 guests