![User avatar](./download/file.php?avatar=708_1378921722.jpg)
Rusty Driver
Posts: 135
Joined: Thu Jan 31, 2013 11:54 am
Hand brake cables
thanks
DT
IHC in the early to mid-fifties.
Rusty Driver
Posts: 135
Joined: Thu Jan 31, 2013 11:54 am
Golden Jubilee
Posts: 759
Joined: Thu Nov 29, 2012 6:44 pm
Location: New Salisbury, IN USA
Golden Jubilee
Posts: 455
Joined: Mon Nov 04, 2013 3:06 pm
Buzzman72 wrote:If your truck has the rear wheel e-brake, there are different length cables based on the wheelbase of your truck. From the MT-63 parts book, for the 115" wheelbase [short bed], the rear cables are the same left and right, part number 83 573 R91. For the 127-inch wheelbase [long bed], the rear cables are also the same part numbers left and right. part number 83 592 R91.
The front cable, from the control to the cross shaft, is part number 83 567 R92 [unless your truck is right-hand drive; that one is 83 746 R92].
I don't have measurements on them--and at near zero, I'm not going to go crawl under the truck. Hopefully, somebody may be able to cross those part numbers over for you.
Golden Jubilee
Posts: 528
Joined: Fri Nov 30, 2012 6:22 pm
Location: Grand Junction, Colorado
Golden Jubilee
Posts: 759
Joined: Thu Nov 29, 2012 6:44 pm
Location: New Salisbury, IN USA
Golden Jubilee
Posts: 455
Joined: Mon Nov 04, 2013 3:06 pm
Buzzman72 wrote:My '52 has the driveshaft drum and band, but it has the lever under the dash. Sounds like a Rube Goldberg setup to me. That's why I have a K-series floor lever for my build. [Besides, IMHO the L-series floor lever looks more like it belongs on a manure spreader than in a truck to me...but I grew up in an IH farm equipment shop.]
Golden Jubilee
Posts: 508
Joined: Tue Jul 16, 2013 2:26 pm
Location: Central PA
Golden Jubilee
Posts: 759
Joined: Thu Nov 29, 2012 6:44 pm
Location: New Salisbury, IN USA
Golden Jubilee
Posts: 8955
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Golden Jubilee
Posts: 5211
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Users browsing this forum: No registered users and 2 guests