OldIHC

That's always one of my favorite moments in an old truck project. It's hard to wipe the grin off your face when all the hard work pays off!

Yea. Owner found a parts truck and wants me to keep working on this project for him. I like having the fun on someone else's dime ha ha ha

And you are helping to get a very rare truck back on the road. It's a Win - win!

Yard drove it a bit today, until the brake line popped. Luckily I had cleaned and adjusted the driveshaft brake.

I bet that got your butt cheeks pinching the upholstery.
After 20 years, the rear brake lines corroded through from the outside, on my R120.
I had the rear brake line burst on my 2002 Ram 2500. The line had rusted through because of a bad assembly procedure. The brake lines were installed in the bottom of the frame rail. A local repair shop replaced all of the lines and flex hoses. I like to have a three year system flush. This was expensive, but a fouled ABS is much more costly.

Anyone have a source or part# for exhaust manifold to pipe gasket? The pipe in the manifold on this truck are shaped to take a donut and the clamp flange is 3 bolt holes. Everything I found online is a flat gasket with only two bolt holes.

With the '3 bolt' 220 240 264 I believe it is a 2-1/2--ID exhaust doughnut. Any good part store would have one or truck store.

Look here
http://www.hansenwebdesign.com/truck/fi ... System.pdf

I have a new one from NAPA Auto still in the package sitting on the shelf, I'll have a look and see what the part # is.

Thanks everyone