Freshly Restored
Posts: 211
Joined: Thu May 10, 2018 7:15 am
6v to 12v - turn signals not working
Finally got the alternator mounted and wiring jiggered around yesterday. Took it for a good ride yesterday and everything worked well except the turn signals. With the ignition switch on, the battery side of the flasher "box" under the dash lights up in the battery hole. The load hole does nothing whether turn switch is on or off. Not sure if it's supposed to. I'm not sure how to figure out the problem. I bought a 12v 3 prong flasher and I tested that running wire leads from a hot source to X prong and ground wire to L prong and the flasher worked.
Any thoughts on how to test for my issue? Should I open up the turn switch and test that and if I should how should I go about doing it? I didn't mess with the switch at all so I don't know why that would be my problem.