Rusty Driver
Posts: 122
Joined: Fri Dec 28, 2018 12:08 am
Rear axle bore
Backing up a bit when I disassembled, the axles/hubs I found the axle had been assembled incorrectly, apparently. The passenger side axle had drifted inward and the hub rubbed the brake spreader bar. I figured this was all due to the broken thrust block. I noticed the pass side bore had no counterbore. So test fitted the race by itself, and it easily bottomed out in the housing. Measuring with a inside mic shows 3-4 thou clearence, which suggests the bearing had spun ? What are some of your thoughts on this . Is it done, I have another axle, but haven't had it apart yet to see if it is good. Trying to keep it original. Sorry, for the long post, Tia for the advice.