Re: Rear End Ratio's.
Posted: Wed Jun 16, 2021 12:57 pmI put a new seal in. I looked for numbers but didn't see any. Where are they supposed to be? I am pretty sure I have the 5:11 gears but would like to know for sure. Thanks.
Page 3 of 3
Posted: Wed Jun 16, 2021 12:57 pmRe: Rear End Ratio's.
Posted: Wed Jun 16, 2021 3:45 pmright on the end where the nut threads on.
Re: Rear End Ratio's.
Posted: Thu Jun 17, 2021 6:23 amthere is also a flat surface on the housing that has numbers cast into it , and although anything could have been changed in the past you can use them to verify what you find by other methods stated in this thread . That's how it was on mine .
Re: Rear End Ratio's.
Posted: Thu Jun 17, 2021 6:43 ammanicmechanic wrote:there is also a flat surface on the housing that has numbers cast into it , and although anything could have been changed in the past you can use them to verify what you find by other methods stated in this thread . That's how it was on mine .
I have never ever seen a center section with the ratio "cast" into it, stamped, yes, cast no. The same casting is used for all available ratios, so the casting number will be the same regardless.
Re: Rear End Ratio's.
Posted: Sat Jun 19, 2021 6:44 amRight , stamped