Rusty Driver
Posts: 117
Joined: Thu Jan 17, 2013 6:29 pm
Cowl vent gasket orientation question
Based upon this then the lip of the cowl vent lid presses against the flat surface of the gasket.
OR
Does the flat surface of the gasket get glued to the bottom of the lid and the profiled portion of the gasket straddle the raised inside lip of the cowl?
It was late when I finally got it all diassembled and only spent about 10 mins investigating the gasket. I was hoping it was stupidly obvious but maybe not
Freemnan Dyson