Golden Jubilee
Posts: 5177
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Re: Kb7 brakes
bedrockjon wrote:cornbinder89 wrote:Either K-6 or K-7 cyl will fit, the -6's are a lttle smaller, but what was fitted depended on the GVW that was spec'd and the time of Mfg. Either will work and unless you run heavy all the time will stop just fine. I had 5 ton on the bed of my K-7 with the smaller cyl and had no trouble stopping, MY other -7 with the bigger brakes has a GVW of 21K and I don't notice a differance.
Use whatever you can find!
again cornbinder these larger wheel cylinders I offered will NOT fit a KB-6, we went thru this before, they would not bolt on my truck that is why I got the other set,
I'm sure I could've made em work with a torch and a lot of drilling, but,,,,
the wheel cylinders I have and listed part numbers for may fit a KB-7, but he needs to check the casting #s.
so, either will work is not a correct thing to tell this guy or anyone.
Ok, But I don't know what is different between yours and mine, as I have one -7 with the smaller cyl and one -7 with the larger and both have the same shoes. I accecpt that you could not fit them, but not sure what is differnet between your set-up and mine. Could you have -5 cly? Or may be the early run of -7 used a uinque cyl with a smaller bore but otherwise identiacl to the later -7, all I know is that one uses a 11/16 bore on the small side and the other uses a 3/4" both the big sides are different also but can't remember the size.