Rookie
Posts: 24
Joined: Fri Sep 18, 2020 4:37 pm
Location: Miami Oklahoma
Drain tubes in windshield body opening
Thanks in advance.
The old and reliable.
Rookie
Posts: 24
Joined: Fri Sep 18, 2020 4:37 pm
Location: Miami Oklahoma
Golden Jubilee
Posts: 5187
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Rookie
Posts: 24
Joined: Fri Sep 18, 2020 4:37 pm
Location: Miami Oklahoma
Rookie
Posts: 24
Joined: Fri Sep 18, 2020 4:37 pm
Location: Miami Oklahoma
Golden Jubilee
Posts: 1887
Joined: Thu Nov 29, 2012 10:40 am
Location: Wichita, Kansas
Golden Jubilee
Posts: 8953
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Golden Jubilee
Posts: 4923
Joined: Thu Nov 29, 2012 11:47 am
Location: Bothell, Washington
nikkinutshop wrote:The IHC COMFO-VISION" cabs suffer rust through in the lower corner of the windshield. The idea of a drain-tube is a good idea for these later cabs to get rid of the water that collects behind the windshield gasket. After rust through, the water drips onto the floor and rusts those floor areas out.
Rookie
Posts: 24
Joined: Fri Sep 18, 2020 4:37 pm
Location: Miami Oklahoma
Golden Jubilee
Posts: 4923
Joined: Thu Nov 29, 2012 11:47 am
Location: Bothell, Washington
cornbinder89 wrote:On the bigger trucks there was a corresponding tube already in the firewall, rubber tubing connected the two. I assume the smaller cabs were the same.
Golden Jubilee
Posts: 5187
Joined: Thu Nov 29, 2012 9:28 pm
Location: Lyman, IA
Users browsing this forum: No registered users and 5 guests