KB-2 rear brake line.
Posted: Thu Sep 17, 2020 7:49 am
The one i am restoring had some brake lines on it and the one i acquired as a backup for parts also had some brakes line. neither was complete however. have had the master cylinder reworked have figured out the fittings and lines needed for the front.
The rear metal lines that go to each wheel come out of a junction block that is bolted to the rear end. My question is the rubber line that feeds fluid to that junction block where does it mount? And I figure it is the same type of fitting..I call them a bulkhead fitting...that mounts to the frame rail at some point.
Thank you for any advise.
The rear metal lines that go to each wheel come out of a junction block that is bolted to the rear end. My question is the rubber line that feeds fluid to that junction block where does it mount? And I figure it is the same type of fitting..I call them a bulkhead fitting...that mounts to the frame rail at some point.
Thank you for any advise.