Page 1 of 1
KB-2 rear axle.
Posted:
Mon Jun 08, 2020 12:47 pmby ks ihc guy
What I am looking for here is the locking washer on the rear. This is the one that goes on the end of the axle you put the nut on then bend the tabs over to keep it tight. When I took this apart one of the washers was rusted to the nut and when they both turned it sheared the tang off that goes in the groove on the axle. My question is would anybody have an extra one or could a guy use either Red or Blue locktite on the nut when tightening it? I have not gone to the parts store to see if something similar is available thought I would check with the experts here first.
Thanks for any help.
Re: KB-2 rear axle.
Posted:
Mon Jun 08, 2020 1:00 pmby bedrockjon
Jacob Chapin makes em, and they are available on ebay too
Re: KB-2 rear axle.
Posted:
Mon Jun 08, 2020 1:32 pmby ks ihc guy
Does he visit this site?
Re: KB-2 rear axle.
Posted:
Mon Jun 08, 2020 4:15 pmby bedrockjon
ks ihc guy wrote:Does he visit this site?
user chapindesign, he posted replies to several posts on Friday, you can email from his profile
Re: KB-2 rear axle.
Posted:
Thu Jun 11, 2020 12:35 pmby ks ihc guy
Jacob Chapin fixed me on these.
T This is a GREAT site.
Thanks for the information.
Re: KB-2 rear axle.
Posted:
Thu Jun 11, 2020 1:38 pmby bedrockjon
Re: KB-2 rear axle.
Posted:
Thu Jan 07, 2021 1:19 amby chapindesign
Hi, I make the washers for the K/KB-2 axles. They are laser cut and fit perfect.