OldIHC

My wife is asking how your little inspector / assistant is doing. This reminds me of my daughter and I in the shop years ago.
I'm up to my butt in snow and more snow is coming.

She is great! She helped me to a little wiring last night before bed.

ha, just noticed, the dog is trying to sneak in the picture too

54 IHC by isu_phi, on Flickr

Built the rear end last night. Hopefully will get to work on the frame this evening

54 IHC by isu_phi, on Flickr

making my boxing plates

54 IHC by isu_phi, on Flickr

I need to fab some kind of cross member support, but the frame is boxed up. I should have taken an updated pic, but the axle is sitting under the frame and ready to get put into position.

I think i am procrastinating a little bit too because this is new territory for me and i am nervous to get it right. I am researching the hec out of installing triangulated 4 links......

Really nice. I had my wife looking for the dog. We miss our dog.

I love my plasma cutter. 1/4" steel like it was warm butter

54 IHC by isu_phi, on Flickr

I used that rectangle tube to start reinforcing the frame as I had to take out the original to box it as far as i wanted to.

54 IHC by isu_phi, on Flickr

OK....this weekend, i think it's time to actually burn in the 4 link

54 IHC by isu_phi, on Flickr

Triangulated 4-Link nearly complete.



checking for binds, cycling through the travel



This week is shaping up to be busy as hec, but i will do my best to get the shock mounts installed.

I feel like i just keep posting the same picture over and over.....but i do know there is a lot of time i am spending here with each of these updates...

54 IHC by isu_phi, on Flickr

I think i have all the brake mounting tabs in the right places, the support is in place. I think i'm ready to blow it apart and get it all painted up now. My next steps are:

1) Get it painted
2) Order drive shaft
3) run brake lines

Then finally time to work on the bed.

Also, from the factory, were there any kind of bushings between the bed and the frame? If so, i doubt there are repops....and i will just figure something out. But, i am curious if there were. With the beds having dump capabilities.......i am doubting there were bushings