Site Admin
Posts: 4938
Joined: Thu Nov 29, 2012 9:10 am
Location: Nampa, Idaho
The place to put your K or KB "Build Off" story.
Site Admin
Posts: 4938
Joined: Thu Nov 29, 2012 9:10 am
Location: Nampa, Idaho
Golden Jubilee
Posts: 488
Joined: Sat Mar 23, 2013 6:36 pm
Location: Pocono Summit , Pa
Golden Jubilee
Posts: 401
Joined: Sun Nov 15, 2015 8:16 am
Golden Jubilee
Posts: 488
Joined: Sat Mar 23, 2013 6:36 pm
Location: Pocono Summit , Pa
Golden Jubilee
Posts: 8946
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Golden Jubilee
Posts: 488
Joined: Sat Mar 23, 2013 6:36 pm
Location: Pocono Summit , Pa
Golden Jubilee
Posts: 8946
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Golden Jubilee
Posts: 609
Joined: Thu Nov 29, 2012 9:55 am
Location: Cassville, Wisconsin
lbesq wrote:One thing I used as an additional storage tank for air is an old electric water heater. Most times these are replaced because they built up calcium and shorted out the lower element. Almost always these tanks are not rusted through. Once stripped down to the steel tank, you need to clean out all, or as much as possible of the calcium. Once done, and dry inside, then you can plumb for air input and output, and appropriate filters. your pancake or two tank compressor will take a bit of time to fill all tanks to pressure shut off. Your pressure start and stop points do not change but capacity is vastly improved.
Golden Jubilee
Posts: 8946
Joined: Thu Dec 27, 2012 12:45 pm
Location: Canada's left Coast
Site Admin
Posts: 4938
Joined: Thu Nov 29, 2012 9:10 am
Location: Nampa, Idaho
Users browsing this forum: No registered users and 3 guests