Motor mounts for D-2
![Post Post](./styles/OldIHC/imageset/icon_post_target.gif)
Posted:
Wed Mar 19, 2014 8:57 pm
by TNbogy
Does anybody know of a source for the rear motor (trans bellhousing) mounts? They are made of rubber and are round.
Re: Motor mounts for D-2
![Post Post](./styles/OldIHC/imageset/icon_post_target.gif)
Posted:
Sun May 04, 2014 8:58 pm
by Hammer
Just found this post and was wondering if you found anything? Getting my engine back this week and I don't know if what I found will work.
Re: Motor mounts for D-2
![Post Post](./styles/OldIHC/imageset/icon_post_target.gif)
Posted:
Sun May 04, 2014 9:01 pm
by TNbogy
I never found a source for the rear mounts. I will try to use the old ones they do not look to bad.
Re: Motor mounts for D-2
![Post Post](./styles/OldIHC/imageset/icon_post_target.gif)
Posted:
Sun May 04, 2014 9:36 pm
by MikeMiller/old
I don't have any advice on replacement mounts on your truck. If your interested, we discussed remaking some mounts and I remade some transmission mounts for my Scout 80. Take a look over at this thread:
http://oldihc.org/phpBB3/viewtopic.php?f=47&t=1671&hilit=Re+rubberWould be an alternative to using a mount in questionable condition. MM