Re: Chassis Chop
Posted: Wed May 23, 2018 11:20 amDid you wait to weld the perches on until you had the engine and tranny in place or did you weld it an an acceptable angle (3%) and then just shim it from there?
SDBinder wrote:Did you wait to weld the perches on until you had the engine and tranny in place or did you weld it an an acceptable angle (3%) and then just shim it from there?
Don't weld your perches until the vehicle is completely assembled. Been there done it. I used my original frame with M11 and used GM 7.5 rear end. I made my own perches, never occurred to me I could purchase axle perches.