Page 1 of 1

New Member--1952 L-110

PostPosted: Wed Dec 06, 2017 7:50 pm
by BobMichaels
Happy holidays, everyone. Bob from University Place, WA. Restoring a 1952 International L-110 that my father bought brand new in 1952. Some rust at the bottom of the cab and pickup bed. Otherwise, not bad shape. New brakes, drums, brake lines. Engine overhauled. Much of the wiring redone. Looking for two grill trim pieces and the "International and L-110" emblems. Any leads on these items? I have scoured the internet and spoke to a few guys. But no luck. Best regards, Bob.

Re: New Member--1952 L-110

PostPosted: Wed Dec 06, 2017 9:23 pm
by lbesq
Hello Bob, Welcome, there are a few fellows over your way. The two Mustache bars are going to be hard and or expensive to come by. My suggestion is to look for a larger truck with the three bars. That would possibly be an L 150. Because they were taller by a bit, the grills are generally in better shape. From that you might actually get the International script you are looking for also. Just a thought. Of Course, someone may have these smaller pieces you are looking for.

Lloyd

Re: New Member--1952 L-110

PostPosted: Thu Dec 07, 2017 4:20 pm
by BobMichaels
Great ideas, Lloyd. Thank you.

Re: New Member--1952 L-110

PostPosted: Thu Dec 07, 2017 4:50 pm
by nikkinutshop
What the "L". there is always room for another Binder on the West Coast. My son has an L110, 100% complete, in pieces and in storage. Welcome. Our "L" engine burns oil, only. (Diesel)

Re: New Member--1952 L-110

PostPosted: Thu Dec 07, 2017 6:47 pm
by dean466
The "International" emblems come up pretty often of Ebay, the "L110" emblems a little less often.

https://www.ebay.com/itm/VINTAGE-INTERN ... 0033.m2042

Are yours missing, or are you looking for better ones? I have a pair that are in better shape than the ones in the listing that I would let go of.

Dean

Re: New Member--1952 L-110

PostPosted: Fri Dec 08, 2017 11:41 am
by BobMichaels
Thank you, Nik and Dean.

Dean, both the International and L-110 emblems are on my pickup. The pot metal has deteriorated to a point where if I pull them off they could very well crumble. So am looking for replacement if I can find them. Not skilled enough to make my own as I have seen on you-tube. Will try to post pics later.