One thing leads to another
![Post Post](./styles/OldIHC/imageset/icon_post_target.gif)
So after rebuilding the cylinder head and getting the truck running, was going to drive the truck out of the garage and have a real good clean up. However it seems i just get one thing right and something else goes wrong. After starting the truck up, i went to drive out only to find that when i tried putting it into gear, i could just got a load of grinding noises. I put my foot on the brake, only for the pedal to sink to the floor.
I checked the brake fluid.....bone dry. I did replace the brake cylinders a couple of years, all bar one, I could not remove the drum. So next job is to look into that.
The grinding noises, i assume is the gear box or rather the clutch, again I'm assuming this is stuck and not releasing. Not sure what to do here, but i be thinking a bit of research first. I will keep posted.
No driving this weekend
Luke
![biggrowl :biggrowl:](./images/smilies/t0103.gif)
I checked the brake fluid.....bone dry. I did replace the brake cylinders a couple of years, all bar one, I could not remove the drum. So next job is to look into that.
The grinding noises, i assume is the gear box or rather the clutch, again I'm assuming this is stuck and not releasing. Not sure what to do here, but i be thinking a bit of research first. I will keep posted.
No driving this weekend
![t2102 :t2102:](./images/smilies/t2102.gif)